SATO GL 4xxe Series Guía de instalación descargar pdf (Pagina 6)

WLAN Card Installation Guide

GL4xxe Wireless LAN Antenna Installation

After installing the LAN card, you will install the antenna for transmission and reception of signals.

Screw the antenna into the connector on the

WLAN card. (Fig 2a)

Rotate the antenna so that it points upward.

(Fig 2b)

3. That completes the installation of the WLAN

NIC and the wireless sub assembly.

st computer with the relevant cables and

turn the printer ON.

5. Refer to the Operator’s Manual for the proce-

re to configure the WLAN settings. A sum-

mary of this procedure is reproduced on the

following page, but the Operator’s Manual

contains further details in the section on

Interfaces Mode (See page 4-57 and subsequent pages).

WLAN antenna

Figure 2a. Installing the

WLAN antenna

Figu

re 2b. Positioning the

4. Connect the printer to the AC outlet and to the

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sin comentarios

SATO GL 4xxe Series Guía de instalación Pagina 6