SATO MB200/201i Manual del operador descargar pdf (Pagina 32)

Operation and Configuration

3-2

Performing a Test Print

Users can perform test prints to evaluate the print

quality and also diagnose problems.

1. Set the printer DIP switch for

Test Print mode as shown

on pages 4-2/4-3.

2. Press the POWER button

while pressing and holding

down the FEED button. The

printer enters the test mode.

Press the FEED button

again to do a test print.

3. Verify the following using the

output of the test printing.

• All printed characters are

solid black, without any chipped areas.

• Overall print quality is readable and sharp.

A low battery condition may affect the print quality.

Make sure the printer is running on AC or on a full

battery during a test print.

Notes:

If any fault is detected, contact your SATO dealer or

service center. Before asking for a repair, please read

the Troubleshooting section of this manual.

MB20xi A6.book Page 2 Tuesday, January 25, 2005 4:07 PM

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 71 72

Sin comentarios

SATO MB200/201i Manual del operador Pagina 32