SATO GL 4xxe Series Guía de instalación descargar pdf (Pagina 12)

12

Liner

Adjust collar

Dispenser

3) Mechanical adjustment of the dispenser

Turn the printer ON and take it OFFLINE (by

pressing the LINE button).

Go into the printer’s ADVANCED Mode and

scroll to the Media Handling menu. Select

Peel-Off to activate the peel-off and rewinder

functions, and then exit the menu. Perform

some printing to test the proper functioning of

the liner rewinder.

Load the label and ribbon according to the

route drawing. The printer starts printing once

it is at test print mode.

Check if the liner winding path meanders to

the left and right. If so, adjust the dispenser

plate. See next step.

The dispenser plate is adjusted via the the

screw of the ‘adjust collar’: turn clockwise to

move the dispenser plate forward toward you.

Turn counter-clockwise direction to move the

dispenser plate toward the printer itself.

Perform adjustment of the adjust collar and

checki the meandering condition during test

prints. Repeat the adjustment until the liner

does not meander to left and right during

feeding and back-feeding.

Note

If ribbon wrinkling occurs, adjust the ribbon

adjust plate.

This marks the end of the installation process.

Figure 3a. Advanced Mode

Media Handling menu

Use the

Media

Handling

menu to

activate the

rewinder

Figure 3c.

A

djusting liner meandering

via the adjust collar.

Figure 3b. Checking the liner winding

path for meandering

ADVANCED MODE

Peel-Off

1 2 ... 7 8 9 10 11 12 13

Comentarios a estos manuales

Sin comentarios