SATO /gt Series Especificaciones descargar pdf (Pagina 122)

Section 5: Interface Specifications

Page 5-40 GT Series Operator’s Manual

5.20 IEEE 1284 INTERFACE

The IEEE 1284 Interface on the printer complies with IEEE1284 standards.

The ECP mode is recommended for LPT1 port settings.

Make sure to change the LPT1 port settings through the BIOS settings.

Basic Specifications

Interface board

Connector Printer Amphenol (DDK) 57 to 40360 (Equivalent)

Cable Amphenol (DDK) 57 to 30360 (Equivalent)

Cable length Under 3 meters

Signal level High level : + 2.4 to + 5.0 V

Low level : - 0.0 to – 0.4 V

Communication settings

One item or Multi communication can be selected using DSW2-5.

DIPSW2-5 Set Range

ON Multi-reception

OFF One Item

Maximum Receive buffer

capacity

2.95Mbyte

Timing chart

0Mbyte

2.95Mbyte

Remain. 0.95Mbyte

Remain. 1.95Mbyte

Near full

Near full clear

DATA

STROBE

ACK

BUSY

s < T1, T2

0.6µs < T3 < 1.2µs

* It is possible to set the ACK width settings (0.5 – 10 µs) in the Advanced

mode, in the case of One Item reception.

ECP mode

Centronics compatible mode

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 151 152

Sin comentarios

SATO /gt Series Especificaciones Pagina 122