SATO LP 100R L Guía de instalación descargar pdf (Pagina 35)

INSTALLATION GUIDE

5.3 Controller Installation, Meto-Logic

1. Open lower Front Door.

2. Locate power strip above main power supply cabinet (see Figure 5-17).

3. Position the Controller in the lower cabinet as shown in Figure 5-15.

4. Connect the monitor AC power cord from the connector panel harness to the Unswitched AC receptacle of

the Printer.

AC Power Strip

Controller

Figure 5-15

CAUTION

The printer power cord must not be connected until after the controller

has been installed.

WARNING

Before installation, the Controller power supply voltage selector switch

must be set to the 230V position.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 79 80

Sin comentarios

SATO LP 100R L Guía de instalación Pagina 35