SATO GL408e / GL412e Manual del operador descargar pdf (Pagina 144)

Unit 6: Maintenance

GL408-412e Operator’s Manual

6-7

PRINT HEAD BALANCE ADJUSTMENT

Print head balance is the equalization of pressure against the platen roller from one end to the opposite. If the print

head balance is out of adjustment, the printed image will be darker on one side of the label than the other and the

media will be prone to travel in the direction of least resistance.

To adjust balance, a scaled dial allows adjustment based on the width of the media used. The setting may be

viewed through the dial window of the upper print assembly. The that table follows coorelates paper width with a

dial setting.

Figure 6-5, Print Head Balance Adjustment

NOTE: Once the balance has been set, the print head pressure must also be set.

Refer to the Print Head Pressure chapter of this manual for instructions.

NOTE: If a desired setting cannot be achieved through the dial alone, loosen the set

set screw, adjust the plate, retighten the set screw, and then readjust the dial.

BALANCE ADJUSTMENT

Paper Width (millimeters) 25 to 55 55 to 85 80 to 110

Dial Setting 12345

Balance Dial

Set Screw

Upper Print Assy

Dial Window

1 2 ... 139 140 141 142 143 144 145 146 147 148

Sin comentarios

SATO GL408e / GL412e Manual del operador Pagina 144