SATO M8485S Manual del operador descargar pdf (Pagina 23)

Loading the Label Stock

1. Open the print head by rotating the Head

Latch until the head releases. It is

spring-loaded in the open position.

2. Unlatch the Label Hold Down by lifting up

on the latch. It is spring-loaded in the

open position.

3. Pull the Label Edge Guide all the way out.

4. Remove approximately 18 inches of labels

from the backing liner.

5. Route the label liner under the Label Hold

Down and under the print head and out

the front of the printer.

6. Pull the liner through the printer until the

first label is positioned under the Label

Hold Down.

7. Push the labels in until they contact the

inside edge of the printer, then position

the Label Edge Guide until it lightly

contacts the outside edge of the label

liner.

8. Close and latch the Label Hold Down and

Print Head.

9. Release the Nip Roller Hold Down by

rotating the Nip Roller Latch tab

clockwise. The Nip Roller Hold Downwill

swing down.

10. Route the liner over the peel bar and

back between the Nip Roller Hold Down

and the Nip Roller.

11. Pull the liner tight. Close the Nip Roller

Hold Down by pushing upward until it

latches in place. Make sure the Nip

Roller Latch is securely engaged.

Note: Always check that the backing paper

is taut between Platen Roller and Nip Roller.

Label Hold Down

Label Edge

Guide

Label Hold Down

Closed

Labels

Nip Roller

Hold Down

Label

Liner

Peel

Bar

Nip Roller

Latch

Section 2. Installation

SATO “S” Print Engines 9001034 Rev. E Page 2-7

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 227 228

Comentarios a estos manuales

Sin comentarios