SATO E Series Manual del operador Pagina 39

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 102
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 38
Head Check Selection (DSW2-3). When selected, the printer will check for head
elements that are electrically malfunctioning.
Hex Dump Selection (DSW2-4). Selects Hex Dump mode.
Receive Buffer Selection(DSW2-5). Selects the operating mode of the receive
buffer. See Section 6: Interface Specifications for more information.
Firmware Download (DSW2-6). Places the printer in the Firmware Download
mode for downloading new firmware into flash ROM.
Protocol Code Selection (DSW2-7). Selects the command codes used for
protocol control. Refer to Appendix E for more information.
M8400 Emulation Mode (DSW2-8). For emulating earlier series software
commands. Should be used only if problems are encountered when using existing
software. This switch will also affect the settings selected by DSW1-7 and DSW1-8.
SATO CL Series “e” Printers PN 9001074 Rev. B Page 3-3
Section 3. Configuration
DSW2-3 SETTING
Off Disabled
On Enabled
12345678
ON
OFF
DSW2
DSW2-4 SETTING
Off Disabled
On Enabled
12345678
ON
OFF
DSW2
DSW2-5 SETTING
Off Single Job
On Multi Job
12345678
ON
OFF
DSW2
DSW2-6 SETTING
Off Disabled
On Enabled
12345678
ON
OFF
DSW2
DSW2-7 SETTING
Off Standard
On Non-Std
12345678
ON
OFF
DSW2
DSW2-8 SETTING
Off Disabled
On Enabled
12345678
ON
OFF
DSW2
Vista de pagina 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 101 102

Comentarios a estos manuales

Sin comentarios